72-tooth ratcheting box end needs a minimal 5° to move fasteners vs
series: 6300–6307
The puller for tie rods and push rods of the series 129 is used for the hydraulic pressing out of the ball pins when removing ball joints on push and tie rods specifically designed for trucks and low-floor buses
The pliers are handy and due to their lightweight adjustability
The Whittet-Higgins SNC20-7S is a two-piece
kukko 221-4 3-jaw puller with conical self-tensioning, up to 150 mm spread, 170 mm reach for centric removal of bearings, gears, and discs in all common sizes for crafts, workshops, and industr Nachi 72-tooth ratcheting box end needsThe 3 jaw pullers with conical self tensioning are used for the centric removal of bearings, gears, and discs in all common sizes for crafts, workshops, and industry. This allows for the loosening of any component that sits on a shaft and is freely accessible from the outside. With the tightening of the tension cone, the puller jaws are automatically centered. By operating the tension cone, the desired spread can be adjusted. Additionally, the puller
